본문 바로가기

Airplane Design

[문서Review]<Section2. Fatigue Strength Evaluation>

728x90
반응형
지난 포스팅에 이어 "Fatigue Evaluation of wing and associated structure on small airplanes, FAA, May 1973" 문서의 Section2. Fatigue Strength Evaluation에 대한 검토를 이어가 보겠다.

https://jin-t.tistory.com/49

 

 

"이 포스팅은 쿠팡 파트너스 활동의 일환으로, 이에 따른 일정액의 수수료를 제공받습니다."

 

[문서 review] <Section1. Introduction> Fatigue evaluation of wing and associated structure on small airplanes, FAA, May 1973

항공기 구조의 피로에 대한 issue에 대해 공부하던 중 오래된 문서이지만 web 상에 공개된 보수적인 방법으로 접근한 신뢰 가능한 문서를 찾았다. 공부한 내용에 대해 review해 보고자 한다. * 아래

jin-t.tistory.com

 

아래 글의 내용(출처는)은 아래 링크에 의해 작성됨

문서 링크(출처) : http://www.tc.faa.gov/its/worldpac/techrpt/afs120-73-2.pdf

<Section2. Fatigue strength evaluation>

1. 일반 사항

    Under this procedure, conservative loading spectra are established, the mean fatigue life of the structure for the spectra is determined and a scatter factor is applied to the mean life to establish the safe life for the structure.

    이 절차에 따라 보수적인 하중 스펙트럼을 설정하고, 스펙트럼에 대한 구조물의 평균 피로 수명을 결정하며, 구조물의 안전 수명을 설정하기 위해 평균 수명에 산란 계수를 적용한다.

    Conservatism in the development of the loading spectra plus the use of the scatter factor is intended to assure that there is an extreamely low probability that any individual airplane will experience a loading spectrum in excess of its fatigue life for that spectrum.

*여기서 말하는 Spectrum은 단수, Spectra는 복수 (Spectrums로도 사용 가능)

2. 하중 스펙트라 (Loading Spectra)

(1) 정적하중 해석의 경우에는 하중의 크기만 요구되지만, 피로해석의 경우에는 하중의 크기와 주파수가 주어져야한다. 이 하중들은 일반적으로 항공기 무게중심(center of gravity)에서 측정된다. 

    - 하중의 종류는:  1)Flight loads, comprised of gust and maneuver occurrences    2) 지상-공중-지상(Ground-Air-Ground, GAG) 영향    3)택시 하중(Taxi load)    4)착륙 충격 하중들(Landing impact loads)

    *위 1)에서 이야기하는 것이, '비행하중인데 돌풍과 기동의 발생으로 구성된 것을 포함하는 것'을 말하는지 (난 이게 맞는 것 같은데) 또는, '비행하중인데 돌풍과 기동 발생으로 구성된 것'인지는 추후 확인 후 수정 하겠음

 

  

728x90
반응형